Filter
Top Products
30 electrolux
IMPORTANT
This appliance must be installed
and serviced by a competent
person as stated in the Gas Safety
(Installation and Use) Regulations
Current Editions and the IEE
Wiring Regulations.
Any gas installation must be
carried out by a competent
person to the relevant Gas
Standards.
The manufacturer will not
accept liability, should the
above instructions or any of
the other safety instructions
incorporated in this book be
ignored.
Connecting to Gas
This cooker is designed to be installed
with an appliance flexible connection.
Connection is made to the RC 1/2 (1/2"
B.S.P.) female threaded elbow supplied
with the appliance (see Fig. 1) located
just below the hotplate level on the rear
right-hand side of the cooker.
The gas bayonet connector can be
fitted directly behind the appliance or
alternatively adjacent to the appliance on
the left hand side. If fitted in a cupboard
access must be available to disconnect
and connect the flexible hose.
It is recommended that a bayonet
type plug in micropoint flexible hose is
used.
Recommended length - 4 feet x 3/8
inch bore.
When the final connection has
been made, it is essential that
a thorough leak test is carried
out on the cooker and
installation.
Ensure that the main
connection pipe does not
exert any strain on the cooker.
Note:
For certain types of gas bayonet
connection used, it may not be possible
for the appliance to be pushed fully back
to the wall stops.
Important:
Flexible tubing MUST comply with
BS.669 Current Edition.
A) End of shaft with nut
B) Washer
C) Elbow
Fig. 1
Gas connection