Filter
Top Products
16 electrolux
GB
10. Insert again the BRITA MAXTRA
cartridge in the funnel as described in
section "How to change the BRITA
MAXTRA cartridge".
How to use the BRITA MAXTRA filter
cartridge
STEP 1: PREPARING THE
CARTRIDGE
To prepare your BRITA filter cartridge,
please remove protective wrapper
(note: cartridge and inside wrapper may
appear moist, this is simply
condensation). Immerse cartridge in
cold water and shake it gently to remove
any air bubbles. The filter now is ready
to use. As required for other water filter
cartridges, there is no need to pre-soak
the new Maxtra Cartridge.
STEP 2: INSERT IN THE WATER
TANK
Remove the tank lid. Before inserting
the cartridge, remove the funnel and
clean it thoroughly by rising it and
wiping it dry. Then thoroughly clean the
inside of the water tank with a damp
cloth and wipe it dry as well. Place the
cartridge into the filter tank and push
downwards until it 'clicks' firmly into
place. The cartridge should stay in
place if the funnel is turned upside
down.
STEP 3: RINSE CARTRIDGE
Take the funnel out of the BRITA water
filter unit, fill it under the tap with cold
tap water and allow it to filter through.
Discard the first two fillings into the sink.
These first two fillings are used to flush
the filter cartridge.
Then place the funnel back into BRITA
water filter unit.
Place the cover back onto the jag and
press it carefully downwards to ensure it
fits correctly into place.
STEP 4: REFILL WATER TANK
To fill the tank with cold water, simply
open the flip top lid, take a jug of tap
water and pour it inside the tank through
the cover as shown into the picture (use
the lid every time that you want to filter
your water).
Important!
In order to avoid risk of spillage of water
during closing and opening of the