Electrolux ENB 40405 S Freezer User Manual


 
26 electrolux
GB
Something N
Something N
ot W
ot W
orking
orking
If the appliance is not working correctly, please carry out the following checks before
contacting your local Service Force Centre.
Symptom
It is too warm in the
refrigerator.
It is too warm in the
freezer.
Water flows into the
chamber.
Water flows onto the floor.
There are too much frost
and ice.
The compressor operates
continually.
The appliance does not
work at all. Neither
cooling, nor lighting
works.
The appliance is noisy.
Cause
Temperature control can be set
incorrectly.
If products are not cold enough or
placed incorrectly.
The door does not close tightly or it
is not shut properly.
Temperature control can be set
incorrectly.
The door does not close tightly or it is
not shut properly.
Products in big quantity to be frozen
were put in.
Products to be frozen are placed too
closely to each other.
The outlet of the chamber can be
clogged up.
Products placed in can prevent water
from flowing into the collector.
The melting water outlet flows not
into the evaporative tray above the
compressor.
Products are not wrapped properly.
Doors are not shut properly or do not
close tightly.
Doors are not shut properly or do not
close tightly.
Products in big quantity to be frozen
were put in.
Too warm food was put in.
The appliance is in too warm place.
Plug is not connected to the mains
socket properly.
The fuse burnt out.
There is no voltage in the mains
socket. (Try to connect another
appliance into it.)
The appliance is not supported
properly.
Solution
Set higher temperature.
Place the products to the appropriate
place.
Check if the door closes well and the
gasket is undamaged and clean.
Set higher temperature.
Check if the door closes well and the
gasket is undamaged and clean.
Wait some hours and then check the
temperature again.
Place the products in a way so that
cold air could circulate among them.
Clean the outlet.
Replace the products so that they can
not touch the back plate directly.
Put the melting water outlet to the
evaporative tray.
Wrap the products better.
Check if the doors close well and the
gaskets are undamaged and clean.
Check if the doors close well and the
gaskets are undamaged and clean.
Wait some hours and then check the
temperature again.
Put food at max. room temperature.
Try to reduce the temperature in the
room where the appliance stands.
Connect the mains plug properly.
Change the fuse.
Start the appliance according to
instructions in chapter 'Putting it into
use'.
Call an electrician.
Check if the appliance stands stable
(all the four feet should be on the
floor).