Filter
Top Products
12
1
2
MAINTENANCE AND CLEANING
The oven should be kept clean at all
times. A build-up of fats or other
foodstuffs could result in a fire,
especially in the grill pan.
Before cleaning, ensure all control
knobs are in the OFF position, and the
appliance has cooled completely.
Cleaning materials
Before using any cleaning materials on your
oven, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should
NOT be used as they may dull the
surface finishes. Harsh abrasives
should also be avoided.
External cleaning
Regularly wipe over the control panel, oven
door and door seal using a soft cloth well wrung
out in warm water to which a little washing up
liquid has been added.
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
• Household detergent and bleaches
• Impregnated pads unsuitable for non
stick saucepans
• Brillo/Ajax pads or steel wool pads
• Chemical oven pads or aerosols
• Rust removers
• Bath/Sink stain removers
Oven Cavity
The enameled oven cavity is best cleaned whilst
the oven is still warm.
Wipe the oven over with a soft cloth soaked in
warm soapy water after each use. From time to
time it will be necessary to carry out a more
thorough cleaning, using a proprietary cleaner.
Oven Door
The door can be dismantled for cleaning as
follows:
- Open the door completely
- There is a small ring on each hinge. Pull
the ring over the claw-like mechanism.
Do this for both hinges. See picture 1.
- Raise the door slightly and pull it straight
outwards away from the oven. The door
will come completely off. See picture 2.
- When replacing the door, locate it back into
the hinge holes. Pull it down fully and slip the
rings off the claw-like hooks.
DO NOT clean the oven door while the
glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes
chipped or has deep scratches, the
glass will be weakened and must be
replaced to prevent the possibility of
the panel shattering. Contact your
local Service Force Centre who will be
pleased to advise further.