Filter
Top Products
ADHESIVE STEAM PROTECTION FOIL
Fit the steam protection on the front part of
the kitchen counter along the entire width.
600 mm
ADJUSTING THE HEIGHT OF THE
APPLIANCE
1. Remove the adjustable plinth.
2. – To lift the front of the appliance, turn
the two front feet counterclockwise.
– To lift the rear of the appliance, turn
the middle screw counterclockwise.
ADJUSTING THE LEVEL OF THE
APPLIANCE
A correct adjustment of the level of the ap-
pliance allows the door to close and seal
correctly. .
If the door does not close correctly, loosen
or tighten the adjustable feet to level the ap-
pliance.
After the adjustment of the level of the ap-
pliance, assemble the adjustable plinth on
the appliance.
INSTALLING THE APPLIANCE UNDER
THE KITCHEN COUNTER OR TO
ADJACENT UNITS
Warning! To prevent injury or damage,
make sure that the appliance is
secured to adjacent safe structures.
The appliance is provided with six fixing
points:
• Two external brackets
• Four internal fixing points.
Use the external brackets when installing
the appliance under the kitchen counter or
to the adjacent units or if the opening for
the appliance is greater than 600 mm.
Use the four internal fixing points if the
opening is 600 mm.
A combination of both fixing methods can
be used if required.
Using the external brackets
1. Install the brackets in the slots on the
top of the appliance.
2. Adjust the height and level of the appli-
ance.
3. Fix the brackets (on the top or on the
side) with the screws supplied. Make
sure that the screws are tight.
Using the internal fixing points
1. Adjust the height and the level of the ap-
pliance.
18 electrolux