Filter
Top Products
Water hardness Water hardness setting
mg/l ppm mmol/l manually electronically
< 70 < 70 < 0.7 1
1
1)
1) No use of salt required.
You must set the water softener man-
ually and electronically.
MANUAL ADJUSTMENT
The appliance is set at the factory at
position 2.
1. Remove the lower basket.
2. Turn the water hardness dial to position
1 or 2 (refer to the chart).
3. Put back the lower basket.
ELECTRONIC ADJUSTMENT
The appliance is factory set at level 5.
1. Switch on the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold button (4) and button (5)
at the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Release button (4) and button (5).
4. Press button (3),
• The indicators of button (4) and but-
ton (5) go off.
• The indicator of button (3) continues
to flash.
• The acoustic signals sound.
• The display shows the setting of the
water softener (example:
and you
hear five acoustic signals = level 5).
5. Press button (3) one time to increase
the water softener level by one step.
Continue to press button (3) until the re-
quired water softener level is achieved.
6. Switch off the appliance to confirm.
USE OF DISHWASHER SALT
Caution! Only use dishwasher salt.
Types of salt that are not suitable for
dishwashers cause damage to the
water softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
program.
Filling the salt container
1. Turn the cap counterclockwise to open
the salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Use the funnel to fill the salt container
with salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
8 electrolux