Filter
Top Products
first use electrolux 13
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
the programme selection/cancel
button on the control panel
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Press and keep pressed the
programme selection/cancel
button until programme light 1
flashes and programme light 2
illuminates with a fixed light.
Wait until programme light 2 turns
off, programme light 1 goes on
flashing and simultaneously the
end of programme indicator light
starts flashing.
This indicates that you have
activated the electronic setting
function of the water softener.
The current level is indicated by
the number of flashes of the end
of programme indicator light and
a pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause,
etc... = level 5
6 flashes, pause, 6 flashes, pause,
etc... = level 6
3. To change the level, press the
programme selection/cancel
button. Each time the button is
pressed the level changes. (For
the selection of the new level see
the chart).
Examples:
if the current level is 5, by pressing
programme selection/cancel
button once, level 6 is selected.
if the current level is 10, by
pressing programme
selection/cancel button once,
level 1 is selected.
4. To memorise the operation, switch
off the dishwasher by pressing the
On/Off button.
117989 53/0en 20-02-2007 15:44 Pagina 13