Filter
Top Products
daily use electrolux 25
Select and start a washing
programme
Select the washing programme
with the door slightly opened. The
start of the programme will occur
only after the closure of the door.
Until then it is possible to modify
the settings.
1. Check that the baskets have been
loaded correctly and that the spray
arms are free to rotate
2. Check that the water tap is opened
3. Press the On/Off button. The
dishwasher must be in setting
mode. The end of programme
indicator light is flashing.
4. Press the programme
selection/cancel button until the
light corresponding to the required
washing programme illuminates
(see "Washing programmes"
chart).
Close the dishwasher’s door, the
programme starts automatically.
Interrupt or cancel a washing
programme in progress ONLY if it’s
absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress:
● Open the dishwasher door; the
programme will stop. Close the
door; the programme will start from
the point at which it was
interrupted.
Cancel a washing programme in
progress
● Open the dishwasher door; press
the programme selection/cancel
button for about 3 seconds, until
the light of the running programme
turns off and the end of
programme indicator light flashes.
The washing programme has been
cancelled and the appliance is now
in setting mode.
● If a new washing programme is to
be selected, check that there is
detergent in the detergent
dispenser.
117989 53/0en 20-02-2007 15:44 Pagina 25