Filter
Top Products
30 electrolux something not working
Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights,
which can be solved with the help of the indications described in the chart,
without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Fault code and malfunction Possible cause and solution
● continuous flashing of the light of the
running programme,
● intermittent audible signal,
● 1 flash of the end of programme
indicator light,
The dishwasher does not fill with water
● The water tap is blocked or furred with
limescale.
Clean the water tap.
● The water inlet hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
● The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose.
● The water tap is turned off.
Turn the water tap on.
● continuous flashing of the light of the
running programme,
● intermittent audible signal,
● 2 flashes of the end of programme
indicator light,
The dishwasher will not drain
● The sink spigot is blocked.
Clean out the sink spigot.
● The water drain hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
Remember to switch off the appliance before carrying out any corrective action.
117989 53/0en 20-02-2007 15:45 Pagina 30