Filter
Top Products
23
Starting a dishwashing cycle
1. Check that the dishes and cutlery are stacked in
the dishwasher in such a way that the spray arms
are free to rotate.
2. Turn on the tap fully.
3. Press the ON/OFF button.
The LED indicators for all the buttons in the con-
trol panel that are now able to be selected will
become illuminated.
4. Press the relevant button for the cycle required
(see “Programme Table”).
The cycle display will become illuminated.
5. Close the dishwasher door. The dishwashing
cycle will begin.
3
If an acoustic error message can be heard
after the cycle has begun, please read the
section “What to do if ...”.
Changing/interrupting/cancelling a
dishwashing cycle
3
Only change or interrupt a dishwashing cycle
that is in progress if it is absolutely neces-
sary. After the appliance has been closed
again, the air that has entered will be heated
significantly and expand. As a result, water
may collect in the base of the appliance and
trigger the anti-flood system.
Changing a dishwashing cycle
3
If you would like to change the dishwashing
cycle before closing the dishwasher door,
briefly press the button for the new dish-
washing cycle.
If you would like to change the dishwashing cycle
after the cycle has commenced, proceed as follows:
1
Hot steam may escape when the dishwasher
door is opened. There is a risk of scalding.
Be careful when opening the door of the
dishwasher.
1. Open the door of the dishwasher. The dishwash-
ing cycle will stop.
2. Press the button for the new dishwashing cycle
and hold it down.
First, the indicator for the dishwashing cycle that is
currently running will flash.
After several seconds only the indicator for the
new dishwashing cycle will be flashing.
3. Release the cycle button.
4. Close the dishwasher door. The newly selected
dishwashing cycle will commence from the begin-
ning.
Interrupting the dishwashing cycle by
opening the dishwasher door
1. Open the door of the dishwasher. The dishwash-
ing cycle will stop.
2. Close the dishwasher door. The dishwashing
cycle will continue.
Cancelling the dishwashing cycle
(RESET)
1. Open the door of the dishwasher.
2. Press function buttons 2 and 3 for approx. 1 sec-
ond and keep them pressed.
The LED indicators for all the buttons in the con-
trol panel that are now able to be selected will
become illuminated.
3. Release the function buttons.
The dishwashing cycle has been aborted.
4. Switch off the dishwasher by pressing the ON/
OFF button.
Load Sensing
If a wash programme is started even though there are
only a few dishes in the upper and/or lower basket, an
intelligent electronic system adjusts the amount of
water and the duration of the wash programme to the
number of dishes. By this means it is possible to
wash only a few dishes quickly and economically. At
half load (6 place settings), up to 2 litres of water and
0.2 kWh of electricity are saved.