Filter
Top Products
26
What to do if ...
Try to rectify minor faults on the dishwasher with the
aid of the instructions given here. If you call in cus-
tomer service to resolve one of the malfunctions
listed here, or rectify an error made in the operation
of the appliance, the customer service engineer’s visit
is not free of charge, even during the period of guar-
antee.
...Error messages are displayed.
If your appliance is equipped with an optical floor sig-
nal, in the event of an error a dot-shaped optical sig-
nal will flash on the floor.
3
Errors will only be indicated acoustically if
the acoustic signal has been activated.
If, as listed in the table below, any of the indi-
cators in the control panel or the display
panel are flashing or are illuminated, and/or if
an acoustic signal can be heard, you can
probably rectify the fault yourself.
After rectifying the fault related to the 1 acoustic sig-
nal or the two acoustic signals press the button for
the commenced dishwashing cycle. The dishwashing
cycle will continue.
If the fault is displayed again, please contact Service
Force.
3
For all other errors displayed, please contact
Service Force stating the error code (see
chapter: Service and Spare Parts).
Malfunction Possible cause Remedy
One short continuously
repeated warning tone
can be heard; the cycle
indicator for the selected
dishwashing cycle is flash-
ing, the end cycle indicator
is flashing once repea-
tedly:
There is no water running
into the dishwasher.
The tap is blocked or furred with lime-
scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose
fitting.
Filters in the base of the washing com-
partment are blocked.
Press the button for the commenced
dishwashing cycle, then cancel the
dishwashing cycle by pressing
RESET (see chapter: Starting a dish-
washing cycle), clean out the filters
(see chapter: Cleaning the filters).
The water inlet hose has not been cor-
rectly laid.
Check hose installation.
Two short continously
repeated warning tones
can be heard; the cycle
indicator for the selected
dishwashing cycle is flash-
ing, the end cycle indicator
is flashing twice repeat-
edly:
The siphon is blocked. Clean out siphon.
The water drain hose has not been cor-
rectly laid.
Check hose installation.
Three short continuously
repeated warning tones
can be heard, the end cycle
indicator is flashing three
times repeatedly.
The leak prevention system has been trig-
gered.
Turn off the tap and contact Service
Force.