Filter
Top Products
12 electrolux first use
Before using your dishwasher for the
first time:
● Ensure that the electrical and
water connections comply with the
installation instructions
● Remove all packaging from inside
the appliance
● Set the water softener
● Pour 1 litre of water inside the salt
container and then fill with
dishwasher salt
● Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: ‘3 in 1’, ‘4 in 1’, ‘5
in 1’ etc... set the 3 in 1 function
(see ‘3 in 1 function’).
First use
Set the water softener
The dishwasher is equipped with a
water softener designed to remove
minerals and salts from the water
supply, which would have a
detrimental or adverse effect on the
operation of the appliance.
The higher the content of these
minerals and salts, the harder your
water is.
Water hardness is measured in
equivalent scales, Clarke degrees,
French degrees (°TH) and mmol/l
(millimol per litre - international unit
for the hardness of water).
The softener should be adjusted
according to the hardness of the
water in your area. Your local Water
Authority can advise you on the
hardness of the water in your area.
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
one of the up and down scrolling
buttons on the control panel
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
117989 78/0en 5-02-2007 12:31 Pagina 12