Filter
Top Products
40 electrolux installation
Water outlet hose connection
The end of the drain hose can be
connected in the following ways:
1. To the sink outlet spigot, securing
it to the underside of the work
surface. This will prevent waste
water from the sink running into
the machine.
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm.
The waste connection must be at a
maximum height of 60 cm from the
bottom of the dishwasher.
The drain hose can face either to the
right or left of the dishwasher
Ensure the hose is not bent or
squashed as this could prevent or
slow down the discharge of water.
The sink plug must not be in place
when the machine is draining as this
could cause the water to syphon back
into the machine.
The total length of the drain hose,
including any extension you might
add, must be no longer than 4 metres.
The internal diameter of the extension
hose must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than
the diameter of the hose provided.
Our appliances are supplied with a
security device to protect against the
return of dirty water back into the
machine.
If the spigot of your sink has a "no
return valve" incorporated this can
prevent the correct draining of your
dishwasher. We therefore advise you
to remove it.
When connecting the drain hose to an
under sink trap spigot, the entire
plastic membrane (A) must be
removed. Failure to remove all the
membrane will result in food particles
building up over time eventually
blocking the dishwasher drain hose
spigot
117989 78/0en 5-02-2007 12:36 Pagina 40