Filter
Top Products
Operating Instructions
26
Starting the Wash Programme
0 1. Check that when the dishes and cutlery are loaded into the dishwasher
the spray arms are free to rotate.
2. Open the tap fully.
3. Shut the door.
4. Press the ON/OFF button The ON/OFF button indicator illuminates.
5. Press the button for the programme required (see “Programme Table“).
The programme indicator and the associated wash programme steps in
the programme progress display illuminate. After around 6 seconds, the
wash programme selected starts. The remaining time for the pro-
gramme calculated from quantity of dishes loaded is displayed in the
multi-display. With automatic programme adjustment this residual
time count can be stopped or corrected if necessary (load quantity,
degree of dirtiness, etc.) using the dishwasher control. The current pro-
gramme step is also displayed in the programme progress display.
3
If fault messages are displayed on the multi-display after the start of
the programme, please read the “What to do, if...“ section.
Changing/Interrupting/Cancelling the Wash
Programme
Changing the wash programme
3
To change the wash programme within the first 6 seconds after the
selection of the programme, briefly press the button for the required
programme.
To change the wash programme at a later point in time, use the follow-
ing procedure:
0 1. Press the button for the new wash program and keep it pressed. The
indicators for both wash programmes now flash.
2. After a few seconds, only the display for the new wash programme
flashes. Release the programme button, the new wash programme is
now carried out.