Filter
Top Products
Operating Instructions
32
Symptom Possible Cause Solution
The programme indicator for
the programme selected is
flashing, the WATER indica-
tor is illuminated and
1 warning tone can be
heard that is continually
repeated: no water is run-
ning into the dishwasher.
Tap is closed. Open tap.
The filter (where present)
in the threaded hose fit-
ting is blocked.
Clean the filter in the
threaded hose fitting.
The water inlet hose
is not correctly laid.
Check hose
installation.
The programme indicator for
the selected programme is
flashing, the multi-display is
indicating the fault code (2
and 2 warning tones can be
heard that are continually
repeated.
The sink outlet is
blocked.
Clean the sink outlet.
The water drain hose
is not correctly laid.
Check hose
installation.
The multi-display is indicat-
ing the fault code (3 and
3 warning tones can be
heard that are continually
repeated.
The anti-flood system
has been triggered.
Close the tap and contact
AEG Service Force.
During a wash programme
the SPRAY ARM indicator
illuminates at irregular
intervals and 1 longer
warning tone can be heard
at the same time.
The middle spray arm is
jammed.
Open the door carefully, as
hot steam can escape when
the door is opened. There is
a risk of scolding! Place the
dishes and cutlery in the
lower basket in such a way
that the middle spray arm
can rotate freely. Close the
door of the dishwasher.
The DOOR indicator is illu-
minated
The door of the dish-
washer is open.
Close the door of the dish-
washer.
The FILTER indicator is illu-
minated.
The FILTER indicator
illuminates at regular
intervals to remind you
to check and clean the
filter in the dishwasher
from time.
The indicator goes out
automatically on the start
of the next wash pro-
gramme.