Filter
Top Products
5
Tools required for installation
Screw driver (pozidrive n°2 , torx 10 and 20)
Allen spanner 4mm
Shifting spanner 10mm
pipe wrench
3
/
8
Electric drill with twist bit Ø 10 mm
Installation
Pre-Installations Calculations (see Figure 2)
1. a) Select a hood preference height P (see Figure 2) that is comfortable for
the user not less than 30.
b) Calculate Hood height your installation H (see Figure 2). H = K-C-P.
c) Confirm that H is within the range of min to max H found for your hood.
If not adjust your installation.
d) Calculate Chimney structure height S (use formulas in Figure 2, and
check dimensions of your hood). Save this calculation for use later in the
installation.
Preparation of Mounting Surface - Installing supports above
ceiling drywall.
Note: Take into consideration the hood depth; your hood could be much
deeper than the cooktop.
2. Mark center lines of cooktop or range on ceiling above. Use centerlines marked
on ceiling to position the mounting template. Note location of hood front, side,
and mounting holes indicated on template.
3. Remove and save template. Cut and remove ceiling drywall. Install suitable
length 2" x 4" lumber between joists to provide chimney mounting points as
shown in Fig. 4 and 5. Use template for dimensions and required clearance.
Make sure to affix the added lumber firmly and level. Consult a professional if you
have difficulties or your installation is unique. Consult template and Figures 3.
4. 5.
Note the weight of the appliance. (see Table1).
4. Install an 8 exhaust duct. Female end shall be 4-1/2" below finished ceiling and
securely fastened to joists. Do not use duct smaller than the transition.
5. Install 1/2" electrical conduit in location marked on template and extend length
S from ceiling.
6. Install drywall around duct and conduit; then refinish ceiling.
A
C (36"std.)
S
H
K
P
K = Kitchen Height
C = Counter Height (36" standard)
P = Height of Hood Bottom above
counter not less than 30
A = Canopy Height
H = Hood height your installation
H = K C P
S=
Chimney Structure Height,
your installation.
S=H A
Figure 2
Figure 3
Figure 4 Figure 5