Filter
Top Products
8
1
2
3
4
5
6
7
8
Nut
rear
Chimney
cover
front
Chimney
cover
X
X
Figure 12
Figure 13
Installation
24. Join the two bottom sections of the chimeny covers to cover the chimney
structure using 6 screws (3 each side, see the plan diagram for joining the two
sections). Figure 12.
25. Slide down the bottom section of the covers in its seat so that it completely
covers the motor compartment and electrical connection box. Figure 12.
26. Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue (CAUTION!
THE BOTTOM FLUE TABS ARE THE NARROWER AND SHALLOWER
ONES).
The wider and deeper tabs are those used for the top flue, and must be cut to
size. Figure 13.
Attention!
Tabs must be fixed using the double sided adhesive tape supplied (two
segments each tab should be used!):
Cut the e tape into 8 segments, then remove the protection covering from both
sides and apply the segments close to the screws that fix the chimney flues to
the structure.
NOTE: Do not overtighten and deform metal.
Turn the main power on again at the central electrical panel and check for correct
hood operation.
27. Make sure to leave this manual for the home owner.