Filter
Top Products
9
Use and Care
Control Pad Functions
Grease Filter Saturation LED
The Suction power 2 LED in Figure 12 is marked with an F. This LED will flash to remind you when the grease filter needs to
be cleaned after 40 hours use. Follow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned,
reset the reminder by pressing Motor OFF button for about 3 seconds until you hear the signal (beep).
Operating Instructions
The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood.
Use the low speeds for normal use and the higher speeds for strong odors or fumes.
Minimize cross drafts which will reduce the effectiveness of the hood.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE HOOD.
For satisfactory use of your hood, become familiar with the various functions of the
hood as described below
Motor OFF button
ON button and
motor suction
power selection
button 1, 2, 3,
1,....
Suction power
1 LED, this led
is ON when
suction power
1 is selected.
Suction power
2 LED, this led
is ON when
suction power
2 is selected.
Suction power
3 LED, this led
is ON when
suction power
3 is selected.
Intensive
Suction power
LED, this led is
ON when the
intensive
suction power
is selected.
Intensive
Suction power
button - this
suction power
will function
for 10 mins.
then the hood
set again the
preselected
speed
Light OFF button
Light ON button
Figure 14