Filter
Top Products
1. Open the door.
2. Remove the transport support from the
door sides.
3. Remove the transport support from the
lower hinge (some models).
Some models are fitted with a silencing pad
under the cabinet. Do not remove this pad.
Rear spacers
Install the spacers provided within the accessory bag as shown in the figure.
Install two spacers on the back side of the panel
and two spacers with adhesive on the lower part.
Connecting the water hose.
Water supply should be provided with a tap and 3/4" male connector within 1,5 m from
the appliance.
This work is to be carried out by a skilled plumber.
There are different type-approved taps and tap assemblies on the market.
The water hose must not be cracked, squeezed or put in tight bends.
Before the appliance is placed its final location, ensure that the water connection has been
correctly carried out, that there is no leakage at the connection to the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly positioned in the connector.
We recommend that the appliance is placed on a "run-off" mat intended for refrigerators
and freezers, which makes it easier to detect possible leakage
18
Installation