Filter
Top Products
24
AEG/Electrolux 8184261-00/9
When the water system is started for the first time.
The following should be carried out when the appliance is correctly
connected to the water supply in the building:
Open the tap on the water connection and start up the refrigerator. The water
system main valve opens and the system starts to fill up. Wait for five
minutes.
Unpack the filter provided and
connect it as follows:
- Remove the filter protective cap
and insert the filter connector into
the filter seat and turn as shown in
the illustration (2) until the filter
engages and the projection on the
filter cartridge is opposite the mark
on the plastic cover. See also the
illustration and the instructions on
the inside of the service hatch.
- Unlock the water dispenser. See the
section "The water dispenser
functions" Select carbonated water
and drain off about 1.5 litres (2.5
pints) of water. There may be some
air to start with.
Connect the gas cylinder provided
as follows:
- Take out the gas cylinder from
plastic bag and screw the gas
cylinder into the adapter (3) for this
purpose, which is located in the
cabinet, doing this by hand without
tools.
- Place the gas cylinder with adapter
in the valve and ensure that the valve
bracket hooks are under the
counterhold on the adapter (5). Then
turn up the bracket lever (6) in one
continuous movement. S ee the
illustration and the instructions on
the inside of the service hatch.
1
2
3
4
5
6