Filter
Top Products
5
AEG/Electrolux 8184261-00/9
BEFORE USE
Position and clean the cabinet as
explained in the section
"Installation".
Check that the drain hose at the rear
of the cabinet discharges into the
drip tray.
Before inserting the power plug into the outlet and switching on
the cabinet for the first time, leave it standing upright for about 4
hours. Otherwise the compressor may sustain damage. This time
will allow the oil sufficient time to return to the compressor.
Using the fridge
To start the fridge and set the correct temperature
Press the ON/OFF-button. The green
indicator lamp lights.
Setting the temperature
Press the buttons until the desired
temperature flashes in the
temperature display (The
temperature can be set between +2°C
and +8°C.)
"+" raises the temperature.
"-" lowers the temperature.
ALARMOFF
ON/OFF
COOLMATIC5
Once set, the temperature display shows "-" until the temperature inside the
fridge reaches +9°C or below.
Allow the cabinet to run for a period of 24 hours whenever the temperature
setting is changed. This will allow the temperature to stabilise inside the
cabinet.
It is not necessary to reset the temperature when the cabinet is switched on
after it has been out of use. The electronics recalls the previously set
temperature.
Temperature inside the fridge
A suitable temperature inside the fridge is approx. +5°C. Storage
temperature in the cabinet is even on all of the shelf levels. The vegetable
box which is placed in the bottom has a temperature of 3-4°C warmer than
the intended temperature setting.