Eurotech Appliances EDW294E Dishwasher User Manual


 
10
DRAIN CONNECTIONS
Eurotech provides a 3/4” (19 mm) ID corrugated drain hose with a drain line holder to form a high loop.
NOTE: Do not use any fittings anywhere in the drain line that are less than 3/4" (19 mm) OD. Stock.
The access hole for the drain line should be 1-1/2" (38 mm).
The high loop is necessary for proper draining and should be
located as close to the dishwasher as possible.
There are three ways to connect the drain supply line, as shown in
the illustrations at right:
A) Typical connection to sink plumbing before trap (high loop drain)
B) Connection to air gap then to the trap.
C)Connection to waste disposer with air gap
NOTE: Don’t forget to remove the knockout or plug
from the disposer fitting.
IMPORTANT THINGS TO KNOW ABOUT DRAIN
CONNECTIONS:
Failure to provide the proper drain connection height (minimum of 20" (508 mm)) above the bottom of the
dishwasher base) or a 20" (508 mm) high loop will result in improper drainage, which will damage the
machine.
No part of the drain hose should be higher than 35" (889 mm) from the bottom of the dishwasher.
The hose must not be drawn straight to a floor well or its
equivalent because it might function as a siphon and empty
the machine.
The drain hose can be extended to a maximum length of 10 feet
(3048 mm). Joints and jointed tubes, if any, must have a minimum
3/4" (19 mm) OD.Stock.
If the drain line is going to be connected to a waste disposer,
be sure to remove the knockout or plug from the fitting on the
disposer before connecting the drain line.
When the installation is ready, open the supply valve and let the
pressure act for a while. Then check that all connections are tight
and there are no leaks.
B) Connection to air gap then to the trap.
C) Connection to waste disposer with air
gap.
A) Typical connection to sink plumbing
before trap (high loop drain)
20" min.
(508 mm)
20" min.
(508 mm)
20" min.
(508 mm)