Eurotech Appliances EDW294E Dishwasher User Manual


 
31
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
Dishwasher does not drain properly
Make sure that the cycle was complete before you opened the dishwasher. If not, allow it to complete and
check again.
Some water left in the sump area near the drain is normal.
If the plumbing code in your area requires an air gap, make sure that it isn’t blocked or plugged.
If the unit is connected to a garbage disposer, make sure the disposer is empty.
If water backs up into the sink, check the garbage disposer and trap for blockage.
Check the dishwasher filters and drain area for blockage. (See page 27.)
Check for a kink in the drain hose.
Dishwasher does not fill properly
Make sure the water supply is turned on.
Make sure the dishwasher is turned on and the door is closed securely.
Check for crimps in the water feed line.
Make sure the water inlet filter isn’t clogged. (See page 27.)
The system is designed to detect an overflow. When it does, it shuts off the circulation pump and turns on
the drain pump. (See “Overfill Protection” on page 28.)
Dishwasher will not start
Make sure the dishwasher is turned on and the door is closed securely.
Make sure the Delay option is not selected.
Check that the water supply is connected properly and the water is turned on.
Make sure the power cord is properly plugged into the wall socket.
Check your fuse box for a blown fuse or tripped circuit breaker.
ERROR MESSAGES ON MODELS EDW254E, EDW274E, AND EDW294E
An error will display in the LCD window if a fault occurs while a program is in progress. The table below
defines each error message.
ERROR DEFINITION
E1 Fill fault. Check that the main water supply is turned on. If it is, call a service technician.
E2 Wash and heating fault. Call a service technician.
E4 Water fill fault. Call a service technician.
E5 Drain fault. Make sure that nothing is blocking the drain and that the outlet hose isn’t kinked. If
that is not the case, call a service technician
E6 Low water fault. Check that none of the dishes have overturned and collected water. If this is
not the case, call a service technician.
E7 Alternating spray arm fault. Call a service technician.
Action to be taken
- Open the water supply valve and reset the dishwasher
- Check and clean the inlet valve filter if necessary
- Reroute the drain hose to eliminate kinks
- Call an authorized service company
- Reroute the water supply line to eliminate kinks
- Verify the water valve is fully open
- If the same problem happens again, contact an authorized service company
- Reroute the drain hose to eliminate kinks
- Check the siphon
- Call an authorized service company
- Clean the filter
- Make sure the pot is positioned correctly during the next cycle
Checks to carry out
- Water supply valve closed
- Inlet valve filter blocked
- Drain hose is kinked
- Drain hose is leaking
- Water supply like is kinked
- Insufficient water pressure
-
Repeat the washing cycle
- The drain hose is kinked
- The siphon is blocked
- The drain pump is clogged
- The filter is clogged
- A pot is placed up side down
When this occurs
During the water cycle
(the program stops)
At the end
of the cycle
At the end
of the cycle
At the end
of the cycle
Error
LED 1
LED 2
LED 5
LED 4
N.B.: Anomalies are signalled in the following way:
all the LEDs remain on, while the LED corresponding to the type of error flashes.
ERROR MESSAGES ON MODELS EDW242C