Filter
Top Products
5
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
INSTALLATION INSTRUCTIONS
Read these instructions carefully and completely before you install the machine. The installation should be
carried out by a qualified person who is familiar with all local codes and ordinances for electrical and plumbing
connections.
If a dishwasher is being installed in this area for the first time, most of the cabinet work, plumbing, and
electrical has to be done before you move the machine into place.
If you are replacing an old dishwasher, you must check the plumbing connection and wiring before you
move the new dishwasher into place.
A built-in dishwasher must be enclosed on the top, both sides and the back. The best place for your dishwasher
is in the kitchen near the sink. This makes it easier to connect the water and drain supply lines.
After you have placed the dishwasher near the installation location, remove the wrappings from the dishwasher.
Be sure to remove any items packaged inside the dishwasher.
NOTE: It is a good idea to inspect for any shipping damage before you proceed with the installation. Should
you find any damage, you should report it to your dealer or builder immediately.
WHAT YOU NEED
TOOLS
1) Phillips No. 2 screwdriver or power screwdriver (preferably with magnetic screw bits)
2) Adjustable 10” crescent wrench
3) Open-ended wrench (1/2", 3/8” and 5/8")
4) Tape measure
5) Spirit level
6) Electric drill with 1-1/2”” drill bit or hole saw (for new installations)
7) Keyhole saw
8) 2-1/2” Squeeze Clamps (for EDW294E door panel installation only)
MATERIALS NEEDED
← Shut-off valve and fittings for water supply line
MATERIALS SUPPLIED WITH UNIT
The items illustrated below are packaged inside each unit for your convenience.
Two 1-1/8” screws
with sleeves
Four 3/4” screws
Four 1-1/2” screws
One rubber washer
Hardware Package
Contents