Eurotech Appliances EDW294E Dishwasher User Manual


 
13
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
Model EDW294E can only be installed with a one-piece custom door
panel that extends from the toe kick to the counter top. The unit comes
with everything needed to make installing the door panel easy. The
door is predrilled for the panel’s mounting screws.
To order a one-piece door, contact your dealer. The part numbers are
listed below:
White 750163400
Black 750163600
Bisque 750163700
Stainless Steel 750163800
ITEMS PROVIDED WITH THE ONE-PIECE DOOR PANELS
These items are supplied with the doors:
One-piece door
Color-coordinated toe kick
Door handle
Handle support bracket
Two 1/2” machine screws for handle
Two 1/2” sheet metal screws for toe kick
INSTALLING THE ONE-PIECE CUSTOM DOOR PANEL
Before fitting the custom panel, the dishwasher must be installed underneath the cabinet.
For this installation, we recommend that you install the 2” fill strip (see page 6) that comes with the unit to hide
the top of the dishwasher and further reduce water noise.
NOTE: Do not fasten the dishwasher to the cabinet until after you have installed the door panel.
1. Remove the custom panel and parts from the packaging.
2. Move the insulation on the back of the custom panel.
3. Slide the handle support bracket to the inside top of the panel.
4. Insert the screws through the support bracket and the panel.
5. Fit the door handle to the screws and secure tightly.
6. Remove the rubber gaskets from inside the dishwasher door and discard.
7. Remove the second and fourth screws from the inside top of the
dishwasher door (as illustrated) and discard.
8. With the door slightly open, position the panel with the holes in
alignment with the door holes and secure it in place with 2-12”
squeeze clamps on both sides.
9. Insert the 1-1/2” screws partially through the dishwasher door.
10. Loosen the clamp on one side enough to align the screws with
the holes in the panel.
11. Secure the screws.
12. Repeat steps 9 and 10 for the other side.
13. Close the door and, if necessary, adjust for square by adjusting
the front levelling legs for proper height clearance.
14. Fasten the dishwasher to the cabinet (see page 9).
FITTING THE EDW294E ONE-PIECE CUSTOM DOOR PANEL
With this installation,
the custom panel
extends 1-13/16”
inches above the
dishwasher control
panel, as illustrated.