Filter
Top Products
90846
19
A. “Manually” adjust the cam tabs by using each “click” as the cam tab is rotated as equivalent to .75 se-
conds.
B. Set up cam wheel #1 with the left and right cam tabs back-to-ack as shown in figure NO TAG.
C. Adjust the cam tabs on wheels #2 through #5 in sequence as shown in the chart. Rotate the cam
wheels manually downward to set each wheel.
D. After the cam tabs are manually set, reconnect power to the ice maker.
E. Rotate the cam wheels slightly to activate the timer motor (#1 tell-tale down).
F. Using stopwatch, time the cam switch tell-tales. Adjust the cam tabs as necessary for required cycle
times.
MANUAL FILLING
In the event that the icemaker is not functioning, the hopper may be manually filled with ice.
1. Open the hinged service door on the upper left aide panel.
2. Put the “Stop/Run” switch in the “Stop” position.
WARNING: Electrical power is on to the agitator motor and gate solenoid. Avoid contact
with these components.
3. Remove the ice drop and ice storage hopper cover.
4. Fill hopper with ice and replace covers. The unit is now ready for dispensing.
CAUTION: Do not use crushed of flaked ice.
Use of bagged ice, which has frozen into large chunks can void warranty. The agitator is
not designed to be and ice crusher. Use of large chunks of ice which “jam up” inside the
hopper will cause failure of the agitator motor and damage the hopper. If bagged ice is used it
must be carefully and completely broken into small, cube-size pieces before filling into the storage
hopper. Dot not allow foreign material to enter the ice storage hopper.