Filter
Top Products
Setting the SCSI ID with Jumpers
To set the SCSI ID using jumpers, follow these steps:
1. Locate the SCSI ID jumper block on the back of the
tape drive, as shown in Figure 1.
2. Install the jumpers on the jumper block to obtain
the correct SCSI ID for your configuration. Figure 3
shows how to position the jumpers for SCSI IDs 0
through 7.
3. Make sure that the DIP switches are set to SCSI ID 0.
On
Off
On
Off
Figure 2 DIP switch settings for the tape drives’s SCSI
Figure 3 Jumper settings for the tape drive’s SCSI ID
December 1993 EXB-8500/EXB-8500c 13