Filter
Top Products
Loading a Data Cartridge
To load a data cartridge into the tape drive, follow these
steps:
1. Ensure that the write-protect switch has been set
correctly for the desired operation, as explained on
page 26.
2. Ifyouhavejustpoweredonthetapedrive,besure
that the green LED is off, indicating that the tape
drive has passed its power-on self-test and is ready
to load the data cartridge.
3. If necessary, press the unload button to open the
door on the tape drive.
4. Insert the data cartridge into the tape drive with the
labelsideupandthewrite-protectswitchfacing
you.
5. Gently close the door. The tape drive automatically
loads the data cartridge and indicates ready status
(green LED on).
Note: Most tape drives load the data cartridge
automatically. However, your application
software may disable the autoload function. If the
data cartridge does not go to the ready state after
you close the door, consult your software
documentation for information.
Unloading a Data Cartridge
Unload Button
The unload button is the only operator control on the
tape drive. It is used to unload the tape from the tape
drive.
The unload button can also be used to clear servo and
other errors. If a servo or hardware error occurs, press the
unload button to reset the tape drive. Then, if necessary,
December 1993 EXB-8500/EXB-8500c 27