Filter
Top Products
5. If necessary, remove one of the floppy disk drives
to provide an empty full-high drive bay for the tape
drive.
CAUTION
If you remove floppy disk drive B to install the tape
drive, be sure to change your system configuration
to reflect this. Refer to your computer owner’s
manual for details on running the system’s setup
program.
Mounting Procedure
Follow these steps to mount the tape drive:
1. Check for the presence of a load resistor in the
computer. If it is present, disconnect the load
resistor cable from the power supply. Refer to your
computer owner’s manual for more information.
2.
Use #6 32 screws to attach two slide rails to the
sides of the tape drive (see Figure 6). The tapered
end of each rail should point toward the rear of the
tape drive.
Figure 6 Attaching the slide rails to the tape drive
18 EXB-8500/EXB-8500c 306261