Filter
Top Products
11
Control Kits
Model Applications
CK-61
All oil-fired systems. Has adjustable electronic post purge.
✓ ✓ ✓ ✓
CK-62
All oil-fired systems. Has thermally activated post purge.
✓✓✓ ✓
CK-63
All oil-fired systems.
(May require optional delay oil valve for simultaneous burner operation.)
✓✓ ✓ ✓
Draft Proving Switch
Secondary Safety Switch
Thermal Post Purge
Adjustable Electronic
Post Purge
Control Kit Installation:
CK-63 remote mounted. For use with
120 VAC oil-fired systems. Electronic
post purge is included (shown with
cover off). CK kits can be mounted up
to 100 feet from venter.
RJR-6 120V Relay
Control Kit*
Control Kits
Control Kits (CK) control the operation of Power
Venters. See the chart below to select the proper
kit for your application.
Model
Part No.
Contact
Material
Load-Rating
(Amps)
Load-Rating
(Volts)
Normally Closed Switch
Switch Type Application
WMO-1
46086900 Silver 10 Amps 120 AC 200°F M SPDT
Manual reset. Designed for use with power
venting and chimney vented systems for
oil-fired applications.
Thermal Safety Switch
Our thermal safety switches efficiently detect flue gas spillage
due to a blocked flue, continuous down drafting or
inadequate draft condition. With the safety switch wired in
series with the burner circuit, the switch will de-energize the
system’s burner or burner control once it senses the spillage
of hot flue gases. It will not allow the burner to restart until
the switch has been manually reset.
* Control Kits are ETL approved accessories when used in conjunction with the SWG and ComboVent Power Venters.
PPC-4 Post Purge
7137FCHVentGuideOil_New:7137FCHVentGuideOil 5/8/08 10:45 AM Page 11