Filter
Top Products
14
Installation instructions
Fastening the cooktop to the counter
1
Turn the cooktop upside down and place it on a soft surface.
2
Spread the seal around the edges of the cooktop with the adhesive side facing down, as shown
in Figs. 6 and 7. Make sure that the whole perimeter is sealed. Cut off any excess material.
3
Mount the supplied clamps and screws onto the cooktop, as shown (without tightening the
screws) if not already fitted.
4
Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the
counter.
5
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the countertop.
Note: if the countertop is thicker than 1 ⁄” (40 mm), recess the underside to between
1
⁄” (30 mm) and 1 ⁄” (40 mm).
Fig. 6 Preparing the cooktop before installation
Fig. 7 Fastening the cooktop to the counter
Adhesive side
21
Clamp position
Fitting the rear clamps
Securing the rear clamps Securing the front clamps
25
/ " (20 mm) min.
32
1 / " (40 mm) max.
9
16
25
/ " (20 mm) min.
32
1 / " (40 mm) max.
9
16
Seal Seal
Clamp
Clamp
Screw
Screw
Seal
Front
Rear
US
CA