Filter
Top Products
26
Cleaning the spray arm and filter plate
Ensure the DishDrawer® is cool before you start cleaning and follow the instructions for
removing the drain filter and spray arm.
1
Unplug the DishDrawer® or turn it off at the
power supply.
2
Unclip the glass supports from the rack wires and
fold all the adjustable racks away, so that they are
upright and close to the top.
3
Remove the base rack carefully. Lift from the
back end first to prevent knocking the
detergent and rinse aid dispenser.
4
Lift the spray arm and shake any foreign material
out.
Rinse the spray arm clean under running water
and wipe with a damp cloth.
5
In the centre of the filter plate there are two rings.
Hold the centre ring still and turn the outer ring
anti-clockwise, about a 1/8 turn. This will release
the filter plate.
6
Lift the filter plate out.
When cleaning the underside of the filter plate,
take care handling the sharp outer edge to avoid
the risk of cuts.
Remove any foreign material, wash in hot soapy
water and rinse thoroughly in clean water. The
heater plate can be wiped with a damp cloth.
7
Replace the filter plate so it lies flat in the base of
the drawer ensuring the filter plate is fully locked
into position with the centre ring.
Important!
To lock the filter plate into position, ensure the lines align
with each other (c) and all three pin pairs firmly interlock (e).
Refer to the diagram for the correct position.
The filter plate must not be able to move about freely.
8
Replace the spray arm back onto the impeller.
9
Replace the base rack, lowering its front edge into
position first.
10
Plug the DishDrawer® back in or turn it on at the
power supply.
Note: Where there is broken crockery or glass in the
drawer, it must be carefully removed to prevent
damage to the DishDrawer®.
Correct locking position of filter
plate with motor assembly
(under spray arm)
a Outer ring
b Impeller
c Correct alignment marks
d Centre ring
e Interlocking pins
a
b
d
e
c
1
1
2
3
4
2
3
4
5
6
Care and cleaning