Filter
Top Products
20
Rinse aid dispenser
We highly recommend the regular use of liquid rinse aid to give the best drying results. Rinse
aid gives a streak free, sparkling clean look to glass and chinaware. In addition it prevents metal
from tarnishing. The rinse aid dispenser is on the inside of the drawer, located underneath the
detergent dispenser. The dispenser holds approximately 50 ml of rinse aid.
Filling the rinse aid dispenser
1
Turn the plug anti-clockwise and remove.
2
Pour the rinse aid into the circular opening.
3
Take care not to spill rinse aid into the DishDrawer®.
Any spillages must be wiped up to prevent excess
foaming. Failure to wipe rinse aid spillages may
result in a service call which will not be covered by
warranty.
4
Fit the plug back into the original position.
How much rinse aid to use
The regulator may need adjusting to suit your water conditions. The lowest setting is ‘1’ and the
highest is ‘5’. Refer to User preference settings section to adjust the rinse aid setting. If there
is excessive foam at the end of the wash, reduce the setting. If dishes are wet or streaky after
drying, increase the setting.
Rinse aid indicator light
If the rinse aid indicator light is red, refill the dispenser. If the rinse aid indicator light is dimly lit
or not lit at all, there is enough rinse aid for the wash.
Note:
Lighter coloured rinse aids will not dim the indicator light as effectively as darker coloured
rinse aids.
When the rinse aid is being dispensed, you may notice some unusual noises during the wash,
this is normal.