Filter
Top Products
19
INTEGRATED MODELS WITH BADGE (GB IE) ONLY - INSTALLING THE FRONT PANELS & BADGE CONTROLS
2
2
1
REATTACH BADGES & EARTH THE PANELS ATTACH PANELS TO PRODUCT
ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS FITTING A CUSTOM TOEKICK PANEL
19b
21b 22b
20b
Push the panel in
then up to locate.
With the front panels fitted, insert
an appropriately sized Philips
screwdriver into the hole above the
door pin and rotate the panels up
or down to align the gaps in your
cabinetry.
Repeat on the other side if
necessary.
Each panel has a maximum travel of
2 mm up or down.
Important!
Ensure that you maintain a minimum
of 8 mm ventilation gap between the
upper and lower panels.
+ or - 2 mm
1
2
Important!
Ensure the rubber seal
between the drawer
and panels is kept in
place.
When refitting the
door pins, ensure
they are orientated
as shown.
Repeat for the other drawer
Repeat for the other drawer
16 mm x5
You can optionally glue your
custom toekick panel onto the
supplied panel
WARNING!
Electrical Shock Hazard
Connect the integrated badge
earth wire to one of the two tabs
provided on the panel bracket.
To earth the panel bracket,
connect the earth wire from the
product to the other tab.
Any custom metal component
(e.g. handle) that extends past the
rubber seal must be earthed too.
Failure to follow these warnings
may result in electrical shock,
injury or re.