Filter
Top Products
15
Installation instructions
11
Attach double sided foam to the back of the water filter head as shown in
Diagram 5. Write the date to be replaced on the filter (date installed +6months).
Remove double sided foam backing and attach filter to the desired position as
located in step 10 (refer to previous page).
12
Run the 6 mm (¼”) tubing to the back of the refrigerator ensuring there is
enough tubing to pull the refrigerator out for service.
13
Connect tubing into the water (solenoid) valve located on the right hand side of
the unit (compressor) compartment as shown in Diagram 7. Beware of hot pipes.
14
Pull gently on tubing to ensure it is locked in as shown in Diagram 8.
15
The completed installation should look like Diagram 9 on page 16.
Fig.8 Waterline connection
to refrigerator
Diagram 7
Diagram 6
Diagram 8
16
Turn isolating tap on and check that all connections are dry and free of drips.
17
Coil water line tubing behind the refrigerator. Push the refrigerator into place being careful not
to kink or squash the water line running into the water (solenoid) valve.
18
Read and follow pages 16 and 17 before using your ice and water system.
Diagram 5
Fig.7 Double sided
foam attachment