Filter
Top Products
8
0
– 2
0
– 2
Installation instructions
Gas inlet pipe
Fastening the installation brackets (fig. 4)
Each cooktop is provided with an installation kit including brackets and screws for fastening
the top to fixture panels from 2 to 4 cm thick.
Turn the cooktop upside down and fasten the brackets “F and R” to the appropriate socket
holes, without tightening the screws “B” for the moment.
Make sure that the brackets are fastened as shown in figure 4.
Fastening the cooktop (fig. 4)
Spread the sealing material “C” out along the fixture hole, making sure that the junctions
overlap at the corners.
Insert the cook top into the hole and position it correctly.
Adjust the position of the brackets “F and R” and tighten screws “B” to block the cooker top
firmly in position.
With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the
cooktop.
Fig. 4
Rear side
Front side
20 mm min.
40 mm min.
B
F
F
F
R
R
20 mm min.
40 mm min.
B
C
R
FRONT
C