Filter
Top Products
16
Installation instructions
regulation screw
G
H
Adjusting the minimum burner
setting
Check whether the flame spreads to all
burner ports when the burner is lit with
the gas valve set to the minimum position.
If some ports do not light, increase the
minimum gas rate setting.
Check whether the burner remains lit even
when the gas valve is turned quickly from
the maximum to the minimum position. If
the burner does not remain lit, increase the
minimum gas rate setting.
To adjust the minimum gas rate setting:
Semi-rapid and triple-ring wok burners
1
Light the burner.
2
Set the gas valve to the position.
3
Remove the knob.
4
Using a small flat screwdriver, turn the screw
(see Fig.15a) to the correct regulation.
Inside crown of dual burner
1
Light the dual burner.
2
Set the gas valve to the position.
3
Remove the knob.
4
Using a small flat screwdriver, turn the screw
“H” (see Fig.15b) to the correct regulation.
Outside crowns of dual burner
1
Light the dual burner.
2
Set the gas valve to the position.
3
Remove the knob.
4
Using a screwdriver, turn the screw “G” (see
Fig.15b) to the correct regulation.
For LPG gas, tighten the adjustment screws
completely.
Fig. 15a Adjusting the minimum burner setting-semi-
rapid and triple-ring wok burners
Fig. 15b Adjusting the minimum
burner setting-Dual burner