8
Installation instructions
Installation alignment
The diagrams below explain how to achieve the correct and proper alignment of visual elements
of the product should it be necessary. This also allows you to align visual elements across
products if this product is installed alongside other companian products.
Inspect the product to check if the gaps are correct
■
There should be a minimum 5 mm gap at the base of the product (ie from the bottom of the
door glass to the shelf). The product can be raised or lowered to achieve this gap by adjusting
the two small feet at the front of the product with a 7 mm spanner.
■
There should be a 5 mm gap between the top of the door glass and the bottom of the control
panel. The control panel can be raised or lowered to achieve this gap by first loosening the two
screws on either side of the product with a tamper proof torx 20 Screwdriver. Once the control
panel is adjusted to suit, ensure the screws are fully tightened again and the panel does not
move. This adjustment also allows you to visually align the product incase the cabinetry is not
square.
Important!
If adjusting the product height or the control panel (or both), ensure the overall product height
still allows the product to be installed into the preconfined cabinetry space.
Do not lower the control panel so much that it touches or interferes with the door.
5 mm
+
+
-
-
5 mm