Filter
Top Products
Page DS_03
Where the DishDrawer is
in an under counter
situation, i.e. built into a
kitchen unit, it is
recommended that bare
wood surrounding the
DishDrawer is sealed with
an oil based paint or
polyurethane to prevent
possible steam damage.
IMPORTANT
IMPORTANT
STEP 1.3 OPTIONS FOR INSTALLING MULTIPLE PRODUCTS
IMPORTANT
IMPORTANT
IMPORTANT
If mounting the
DishDrawer near the
bottom of the cabinet,
ensure there is adequate
room underneath the
supporting cabinet to
tighten bolts.
Ensure the cavity sides are
plumb (vertical) as this will
assist with leveling the
DishDrawer.
Ensure the Services Hole is
as close as possible to the
rear corner of the cabinet.
The hole can be located
on either side depending
on the location of the
services.
On corner installations
ensure that there is a gap
of 2" (50mm) minimum
between the adjacent
cabinetry and sides of
drawers.
STEP 1.4 ELECTRICAL, PLUMBING & DRAINAGE INFORMATION
ELECTRICAL
GROUNDING INSTRUCTIONS
PLUMBING - WATER SUPPLY
a) The water connection is to be made to a hot water supply only. Ensure the water
temperature is not greater than 140°F (60°C).
b) A readily accessible shut off valve must be installed in the supply pipe.
c) The water supply pressure is to be between 4.3 p.s.i. minimum and
139 p.s.i. maximum.
d) The inlet supply hose must be connected to the water supply using a
3
/
8
"
compression type water supply fitting.
e) Ensure sealing washer supplied with connection hose is fitted.
This appliance must be grounded. In the event of malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least
resistance for electric current.
This appliance is equipped with a cord having an equipment-grounding conductor and a
grounding plug. The plug must be plugged into an appropriate outlet that is installed and
grounded in accordance with all local Codes & Ordinances.
Care should be exercised when the appliance is installed or removed, to
reduce the likelihood of damage to the power supply cord.
If the power supply cord is damaged, it must be replaced by the Manufacturer, its Service
Agent or a similarly qualified person, in order to avoid a hazard.
The power supply receptacle for the appliance should be installed in a cabinet or on a wall
adjacent to the under counter space in which the appliance is to be installed.
The power supply receptacle should be positioned between 6" and 18" (150mm and
450mm) from the cabinet opening of the DishDrawer.