Filter
Top Products
33
Do not use the following on the ceramic glass cooktop:
• Do not use abrasive cleaners and scouring pads, such as metal and
some nylon pads. They may scratch the cooktop, making it more
difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach, ammonia or oven
cleaners, as they may etch or discolor the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they can leave
soil or lint on the cooktop which can burn and cause discoloration.
Note: Additional cooktop cleaning cream may be ordered by visiting the
Frigidaire website at www.frigidaire.com
Cleaning Recommendations for the Ceramic Glass Cooktop (cont’d)
Care & Cleaning
Fig. 3
Removing and Replacing the Oven Door (all models)
The door is heavy. For safe, temporary storage, lay the door flat
with the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor - See Fig. 1).
2. Remove 2 screws located on the inside of the oven door liner (See A Fig.
2)
3. Insert the 2 screws into the door hinge holes located on the side of the
hinge arm, one into each hinge (See B Fig. 2).
4. Close oven door until the door stops, (Do not force the door to close any
further). The placement of these screws should keep door open in about a
45 degree position.
5. Grasp oven door firmly on both sides and slide door up and off hinges at the
same angle. (See Fig. 3)
6. To clean oven door, follow the instructions provided in the Cleaning Chart at
the beginning of the Care & Cleaning section (See Door Liner).
To Replace Oven Door:
1. Be sure the hinge arms remain at the 45 degree angle position. Be sure the
screws are still locking the hinge arms from moving. If the screws fall out
of the hinge holes, the hinge(s) may snap back against the oven frame and
could pinch fingers or chip the porcelain finish on the oven front frame.
2. Hold door at the sides near the top while resting the lower front of door on
your knee. Insert the door channels at the bottom of door over the door
hinges, (See Fig. 3).
3. Allow the door to slide down into the door hinges evenly at the same 45
degree angle. The hinge arms should be inserted into the bottom corners as
far as they can go.
4. Open door completely (horizontal with floor) and remove both screws from
holes in door hinges.
5. Reinstall the 2 screws into the door liner (See C Fig. 2).
6. If the door is not in alignment with the oven frame, remove door and repeat
the above steps.
Fig. 2
Fig. 1