Filter
Top Products
Figure 1
Figure 2
About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface
elements located below the surface of the glass.
The design of the ceramic cooktop outlines the
area of the surface element underneath. Make
sure the diameter of the pan matches the
diameter of the element outline on the cooktop
(See Fig 1). Heat is transferred up through the
surface of the cooktop to the cookware. Only
flat-bottom cookware should be used. The type
and size of cookware, the number of surface
elements in use and the settings, are all factors
that will affect the amount of heat that will
spread to areas beyond the surface elements.
The areas surrounding the elements may
become hot enough to cause burns.
About the Radiant Surface Elements
The element temperature rises gradually and
evenly. As the temperature rises, the element
will glow red. To maintain the selected setting,
the element will cycle on and off. The heating
element retains enough heat to provide a
uniform and consistent heat during the off cycle.
For efficient cooking, turn off the element
several minutes before cooking is complete.
This will allow residual heat to complete the
cooking process.
Figure 1
NOTE: Please read detailed instructions for ceramic glass cooktop
cleaning in the Care & Cleaning section and Before You Call
checklist sections of this Use and Care Manual.
NOTE: Radiant elements have a limiter that allows the element to
cycle on and off, even at the HI setting. This helps to prevent
damage to the ceramic smooth top. Cycling at the HI setting is
normal and can occur if the cookware is too small for the radiant
element or if the cookware bottom is not flat (Refer to page 11 for
using correct cookware instructions with the cooktop).
Locations of the Radiant Surface
Elements and Controls
Your range is equipped with radiant surface
burners with 6 different wattage ratings. The
ability to heat food quicker and in larger volumes
increases as the element wattage increases.
The radiant surface elements are located on the
cooktop as follows (See Figure 2); a smaller 6
inch radiant element located at the right rear
position; a dual 6 or 9 inch radiant element
located at the right front position; a Warmer
Zone radiant element at the center rear position
(See page 12); and 2 (two) 8 inch radiant
elements located at both the left front and rear
positions. Located between left front and rear
elements is a Bridge radiant element.
The BRIDGE radiant element is controlled using
the same knob that controls the left front radiant
element position. See pages 10 and 11 for more
information about using BRIDGE radiant
element.
7
Setting Surface Controls
Left front
Left rear
Right front
Right rear