Filter
Top Products
34
Care & Cleaning
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the Warming Drawer.
Removing and Replacing the Warming Drawer (some models)
NOTE: The Warming Drawer will NOT operate while in the “Self-Clean” and “Oven
Lockout” modes.
Operating and Replacing the Oven Light
Be sure the range is
unplugged and all parts are COOL before
replacing the oven light. Wear a leather-
faced glove for protection against possible
broken glass.
To operate the Oven Light:
The interior oven light will automatically turn on when the oven door is
opened. Press to turn the light ON and OFF when the oven door is
closed. The oven light is located at the rear wall of the oven interior and is
covered with a glass shield held by a wire holder (See Fig. 3). The oven light
glass shield must be in place whenever the oven is in use.
To Remove Warming Drawer:
1.
Turn power off before removing the Warming Drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw
(See Figure 1). Using a 1/4” socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warming Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (See Figure 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer into the range until levers “click” (approximately 2”). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers “click” or the bearing glides do not feel seated remove
the drawer and repeat steps 2-4. This will minimize possible damage to
the bearing glides. Using a 1/4” socket and ratchet replace the shield.
To Replace the Oven Light:
1. Turn electrical power off at the main source and unplug the range.
2. Press Wire Holder to one side to release the glass shield.
3. Replace the old bulb with a new 40 watt appliance bulb.
4. Replace Glass Shield over bulb and snap Wire Holder into place.
5. Turn power back on again at the main source (or plug in the range).
6. The clock will then need to be reset. To reset, see Setting the Clock in
this Use & Care Manual.
Figure 1
Figure 2
Figure 3
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining
the appearance of stainless parts. Please refer to the table provided at the beginning of the Care & Cleaning section in
this Use & Care Manual.
Care & Cleaning of Stainless Steel (Stainless Steel models only)