Filter
Top Products
5
This Use & Care Guide provides general operating
instructions for your model. Use the unit only
as instructed in this Use & Care Guide. Before
starting the appliance, follow these important
rst steps.
1” (25 mm)
1”
(25 mm)
⅜”
(10 mm)
⅜”
(10 mm)
Required Tools
You will need the following tools:
INSTALLATION
Phillips™
Head or
#2 Square Drive
Head
(OR)
AND
OR
Socket
Wrench Set
Adjustable
Wrench
OR
⅜" Fixed
Wrench
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• If possible, place the unit out of direct
sunlight and away from the range,
dishwasher or other heat sources.
• Install the appliance on a oor that is level
and strong enough to support the unit fully
loaded.
CAUTION
DO NOT install the appliance where the temperature will drop below 55°F (13°C) or rise above
110°F (43°C). The compressor will not be able to maintain proper temperatures inside the unit.
DO NOT block the kick plate on the lower front of your appliance. Sufcient air circulation is
essential for the proper operation of your unit.
Installation
Installation clearances:
• Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides - 3/8 inch
Top and Back - 1 inch
• Allow for trim kit if it is to be installed with
the unit.
NOTE
If your unit is placed with the door hinge side
against a wall, you may have to allow additional
space so the door can be opened wider.
Door Handle Mounting Instructions
1. Remove handle from carton and any other
protective packaging.
NOTE
The exterior walls of the appliance may become quite warm as the compressor works to transfer heat
from the inside. Temperatures as much as 30ºF warmer than room temperature can be expected.