Filter
Top Products
9
°F
Setting the PRO-SELECT™ Electronic Control
Cool Down Period
For safe food storage, allow 4 hours for the appliance to cool down completely. The unit will run
continuously for the rst several hours.
Pro-Select™ Electronic Control
The Pro-Select™ Electronic Control is located inside the appliance. Temperature is factory preset to
provide satisfactory food storage temperatures. However, the temperature control is adjustable to
provide a range of temperatures for your personal satisfaction.
PRO-SELECT™ Electronic Control Features
Replace Air Filter
When the “REPLACE AIR FILTER” LED is illuminated yellow, the air lter needs to be replaced. The
control will signal for air lter replacement after 3600 hours of refrigerator operation. After replacing
the air lter, reset the air lter timer by pressing the AIR FILTER key for 3 seconds. The “REPLACE
AIR FILTER” LED will be illuminated green for 3 seconds, conrming a timer reset.
°F
ELECTRONIC CONTROL
To adjust the temperature setting, press the UP () key for warmer temperature and DOWN ()
key for colder temperature on the control panel. Allow several hours for the temperature to stabilize
between adjustments. The unit can be adjusted between -10°F (-23°C) and 10°F (-12°C). By
pressing the TEMP MODE key, the temperature display will toggle between °F and °C.
To turn the appliance OFF, press the UP () key until the warmest temperature setting of 10°F
(-12°C) shows in the display. Then press the UP () key 3 times within 3 seconds to turn the unit
OFF. The display will then show “OF”. To turn the unit back ON, press the DOWN () key 3
times within 3 seconds. The control will then display “10°F (-12°C)” and may be adjusted to the
desired temperature.
Control Lock
To disable the keypads on the control, begin by pressing the CONTROL LOCK key for 3 seconds until
“LO” is displayed for 1 second. With the control locked, when keys are pressed on the control panel,
“LO” will be displayed. To unlock the control, press the CONTROL LOCK key for 3 seconds. The
display will show “UL” for 1 second.
°F