Filter
Top Products
11
CARE & CLEANING
CLEANING THE BURNER GRATES
The burner grates are dishwasher safe and may be
cleaned in the dishwasher. Remove any excessive soils
before placing in the dishwasher.
CLEANING THE BURNER CAPS
Should you ever need to remove the burner caps for
cleaning lift the burner cap off the burner head. Clean
heavy soils with an absorbent cloth. Rinse with a clean,
damp cloth and immediately thoroughly dry including the
bottom and inside of the cap. Do not use harsh abrasive
cleaners. They can scratch the porcelain on the cap. Do
not clean burner caps in dishwasher.
When placing the burner caps, see Important note below.
Your appliance is shipped with the burner heads and
burner caps in the correct locations. Before using your
gas appliance be sure to:
● Follow installation instructions before operating.
● Remove all packing tape from cooktop area.
CAUTION
● To avoid possible burns use care when cleaning the
cooktop. DO NOT attempt to clean the cooktop
whenever the cooktop or burner heads are still hot.
● To avoid possible burns DO NOT attempt any of
the following cleaning instructions provided before
turning OFF all of the surface burners and allow
them to cool.
● To avoid possible burns DO NOT attempt to operate
the surface burners without the burner caps.
IMPORTANT
● For proper gas fl ow and ignition of the burners
— DO NOT allow spills, food, cleaning agents
or any other material to enter the gas orifi ce
opening.
● The cooktop is not removable. Do not attempt to
remove or lift the cooktop.
IMPORTANT
When placing the burner caps on the cooktop, be sure
the burner caps are seated fi rmly on top of burner
heads. Improper fl ame size and uneven heating may
result when any surface burners are turned ON and the
burner caps are not seated correctly.
CLEANING THE BURNER HEADS
Lift the burner cap from the burner head. The surface
burner heads are secured to the cooktop and must be
cleaned in place.
For proper gas fl ow it may be necessary to clean the
burner heads and slots. To clean, fi rst use a clean DAMP
cloth to soak up any spills. Remove any food from
between the burner slots using a small nonabrasive brush
like a toothbrush and afterwards wipe using a damp
cloth. For stubborn soils located in the slots, use a small-
gauge wire or needle to clean.
Should you experience ignition problems it may be that
an ignition port hole is partially blocked with soil. With
the burner head in place, use a small wire gauge needle
or the end of a paper clip to clear the ignition port or
ports.
Slots
Ignition port
Orifi ce port
Slots
Ignition port
Orifi ce port
Orifi ce port
Figure 2- Dual ring burner head
Figure 1- Regular burner head