Filter
Top Products
7
BEFORE SETTING SURFACE CONTROLS
PLACEMENT OF BURNER HEADS AND
CAPS
Burner Cap
Burner Head
Fig. 1
Correct Burner Cap
Placement
Fig. 2
Incorrect Burner Cap
Placement
Fig. 3
Burner Cap Lip
Round Style Burners
The burner cap lip (See Fig. 1) should fi t snug into the
center of burner head and rest level. Refer to Figs. 2 &
3 for correct and incorrect burner cap placement. Once
in place, you may check the fi t by gently sliding the
burner cap from side to side (page 6, fi g. 2) to be sure
it is centered and fi rmly seated. When the burner cap lip
makes contact inside the center of the burner head you
will be able to feel it . Please note that the burner cap
should NOT move off the center of the burner head when
sliding from side to side.
Burner Caps
Fig. 4
Fig. 5
Recessed area
Burner Head
Double Ring Style Burners
The Double Ring burner only operates properly with two
burner caps in place. Be sure the burner cap lips are
positioned facing down towards the burner head (Fig. 4)
and into the recessed areas (Fig. 5) on each side of the
burner head. Be sure both burner caps are seated fi rmly
and rest level on the burner head before operating.
Check the fi t for each cap using the same method for the
round burner caps by gently sliding each cap from side
to side. Please note that the burner cap lips should NOT
move out of recessed areas of the burner head.