Filter
Top Products
9
SETTING SURFACE CONTROLS
Figure 2
SETTING THE DUAL RING BURNER
The Dual Ring Burner has two rings of fl ame that you can
control for two different heat levels, one for small and
one for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob down and turn
counterclockwise out of the OFF position.
3. Release the knob and rotate to the LITE position
(Figures 2 & 3). Note: All electronic surface ignitors
will spark at the same time. However, only the
selected surface burner will lit.
4. Visually check that the burner has lit.
5. When the burner is lit, continue to turn the control
knob counterclockwise between the “HI” position
and the “4” position (fi gure 3) to adjust to the
desired fl ame size for both burners together. DO
NOT cook with any of the surface control knobs in
the LITE position (The electronic ignitor will continue
to spark if the knob is left in the LITE position).
Figure 1
Figure 4
Figure 3
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob in and turn
counterclockwise out of the OFF position (See
Figures 2 & 3).
3. Release the knob and rotate to the LITE position.
Note: All electronic surface ignitors will spark at the
same time. However, only the Dual Burner will ignite.
4. Visually check that zone A & B of dual burner
has lit.
5. Continue to turn the gas control knob
counterclockwise past the “4” position; zone B will
turn off. Adjust the simmer fl ame size by turning the
control knob between the “4” position to the “LO”
position (fi gure 3). DO NOT cook with the surface
control knob in the LITE position (The electronic
ignitor will continue to spark if the knob is left in the
LITE position).
A
B