Filter
Top Products
20
SETTING OVEN CONTROLS
Í
NOTE
When the oven is cool, wipe away any residue or powdered
ash with damp cloth or paper towel.
SETTING QUICK CLEAN OR SELF-CLEAN
CYCLE TIME LENGTH
The Quick Clean and Self Clean pads control the Self-
Cleaning feature. If you are planning to use the oven
directly after a self-clean cycle remember to allow time
for the oven to cool down and the oven door to unlock.
This normally takes about one hour. So a 3 hour self-
clean cycle will actually take about 4 hours to complete.
*It is recommend to use a 2 hour Quick clean cycle for
light soils, a 3 hour Self clean cycle for average or heavy
soils (to assure satisfactory results).
To set the controls for a Quick Clean or a Self
Clean cycle or a Delay Start Quick Clean or a Delay
Start Self Clean cycle
1. Be sure the clock is set with the correct time of day
and the oven door is closed.
2. Press Start time pad.
3. Press and hold the Up Arrow pad to scroll to the
time to start the delayed Self Clean cycle. Release the
pad when the desired time is displayed.
4. Press Quick Clean (for a 2 hour cycle) or Self Clean
pad (for a 3 hour cycle). “- -” appears in the display.
5. Press the Up Arrow pad once. As soon the controls
are set, the motor driven lock will begin to close
automatically and the door locked indicator light will
fl ash. DO NOT open the oven door while the light is
fl ashing (It takes about 15 seconds for the oven door
to lock).
6. “CLn” will appear in the display during the Self Clean
cycle and the Door Locked light will glow until the
Self Clean cycle is completed or cancelled and the
oven temperature has cooled.
When the Self-Clean Cycle is Completed
1. The time of day or “End” will appear in the display
window and “CLEAN” and “DOOR LOCK” light will
continue to glow.
2. Once the oven has cooled down for about 1 HOUR,
and the “DOOR LOCK” light has gone out, the oven
door can be opened.
3. If “End” is in the display and clean indicator light
remains ON, press the CANCEL pad. The time of day
will appear in the display.
Stopping or Interrupting a Quick Clean or Self
Clean Cycle
If it becomes necessary to stop or interrupt a self clean
cycle:
1. Press CANCEL.
2. Once the oven has cooled down for about 1 hour and
the “DOOR LOCK” light has gone out, the oven door
can be opened.
3. Restart the Self Clean cycle once all conditions have
been corrected.
ADJUSTING OVEN TEMPERATURE
Your oven thermostat has been precisely set at the
factory. This setting may be differ from your previous
oven, however, so your recipe times may not give you
the results you expect. If you think the oven is cooking
too hot or cool for your recipe times, you can adjust the
thermostat so that the oven cooks hotter or cooler then
the temperature displayed.
Í
NOTE
The oven temperature adjustments made with this feature
will not change the Self-Clean cycle temperature.
To adjust the oven temperature:
1. Press and hold the BAKE pad for 8 seconds. The
display now indicates the amount of degrees offset
between the original factory temperature setting and
the current temperature setting. If the oven controls
has the factory calibration, the display will read “0°”.
2. The temperature can now be adjusted up or down
35°F or 19°C, in 1°F or 1°C steps by pushing and
holding the Up or Down arrow pad. Adjust until
he desired amount of degrees offset appears in
the display. When lowering the oven temperature,
a minus sign (-) will appear before the number to
indicate that the oven will be cooler by the displayed
amount of degrees.
3. When you have made the desired adjustment, wait
5 seconds and the display will go back to the time of
day.