Filter
Top Products
24
CARE & CLEANING
CAUTION
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
CAUTION
The door is heavy. For safe, temporary storage, lay
the door fl at with the inside of the door facing down.
The oven door can be removed to make oven cleaning
easier.
CAUTION
BE SURE OVEN IS COOL
Changing oven light
The interior oven light will turn ON automatically when
the oven is opened. The oven light may be turned on
when the door is closed by using the oven light switch
located on the Electronic Oven control. The oven light
bulb is covered with a glass shield held in place by a wire
holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE
WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
1. Turn the power OFF at the
main source.
2. Wear a leather-faced glove
for protection against
possible broken glass.
3. Replace bulb with a 40
Watts appliance bulb only.
4. Press wire holder to one
side to release glass shield,
change bulb and be sure to
replace glass shield.
To Remove Oven Door:
1. Open door approximately 4
inches to the stop position.
2. Grasp door at side edges.
3. Lift door up and off hinges.
4. To clean oven door, see the
cleaning chart at beginning of
this section.
To Replace Oven Door:
1. Be sure the hinge arms are in
the stop position. Be careful if
Removing and replacing the main oven door
pulling the hinges open by hand.
The hinges may snap back against the oven frame
and could pinch fi ngers.
2. Hold the door at the sides near the top.
3. Slide the door down onto the hinges as far as it will
go and close the door.
4. If the door is not in line with the oven frame, remove
door and repeat the above steps.
Storage Drawer
Use the storage drawer for storing cooking utensils. The
drawer can be removed to facilitate cleaning under the
range. Use care when handling the drawer.
To open the storage drawer, push the drawer in gently and
it will spring open. To close, push the drawer until you hear
a click, which indicates that the spring is compressed, and
the drawer is closed.
To Remove the Storage Drawer:
1. Open and empty the drawer of all utensils.
2. Pull drawer out to the drawer stop.
3. Lift the front high enough to allow the drawer to be
pulled out.
To Replace the Storage Drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the end rollers onto the guide rails.
3. Hold the drawer in a horizontal position, then push in
until a click is heard.
WARNING
Flammable materials should not be stored in an oven,
near surface elements or in the storage drawer. This
includes paper, plastic and cloth items, such as cookbooks,
plasticware and towels, as well as fl ammable liquids. Do
not store explosives, such as aerosol cans, on or near
the range. Flammable materials may explode and result
in fi re or property damage.
Storage Drawer
Roller
Guide Stop
Front Frame