Filter
Top Products
10
NOTE:
Turn blower and lights off. Make sure the lights are cool.Turn blower and lights off. Make sure the lights are cool.
Turn blower and lights off. Make sure the lights are cool.Turn blower and lights off. Make sure the lights are cool.
Turn blower and lights off. Make sure the lights are cool. If new
lights do not operate be sure lights are inserted correctly before calling
service.
Replace Lights (Figure 14)
• Remove lens cover by removing screw and pulling cover down.
• Pull out fluorescent tube and replace with Philips Type
PL-S 9 Watt maximum.
• Replace cover and secure with screw.
NOTE: Disconnect the hood from the electricity before checking or replacing
fuses.
• Fuses are located on the bottom of blower behind filters.
• Remove cover and check fuses. Figure 15.
• Replace with type 5 x 20mm, 3.15A
slow blow only. slow blow only.
slow blow only. slow blow only.
slow blow only. (Examples are
Radio Shack Cat # 270-1065 or Little Fuse T3.15A 218).
Figure 14Figure 14
Figure 14Figure 14
Figure 14
Figure 15Figure 15
Figure 15Figure 15
Figure 15
Lights replacementLights replacement
Lights replacementLights replacement
Lights replacement